Product Description
Worlds most versatile 1.5 kW dummy load has a built-in true peak reading SWR/Wattmeter
that you can switch and use independently!
YOU WILL FIND TONS OF USES
-
Tune up your transceiver, linear amplifier, or antenna tuner into a safe 50 Ohm dummy load at full power. Then instantly switch to your antenna and monitor SWR, forward, and reflected power.
-
Use for testing/tuning transmitters, transceivers, amplifiers, antenna tuners, baluns, transformers, filters, matching networks, coax, stubs, transmission lines, and antennas.
-
The 50-Ohm dry dummy load works DC to 60 Mhz. SWR is below 1.3:1 at 30 MHz.
-
Can handle 100 Watts for ten minutes or 1500 Watts for ten seconds.
-
Comes with power derating curve.
-
Extra-large three-inch lighted Cross-Needle Meter reads SWR (1:1 to 8:1), forward, and reflected power simultaneously.
-
Reads true peak PEP or average power on 300/3000 Watts forward and 60/600 Watts reflected power ranges 1.8-54 MHz.
-
High accuracy comes from a carefully designed directional coupler, an accurate active-peak reading circuit and a precision dArsonval meter movement.
-
RF tight perforated aluminum cabinet. 4½W x 3½H x 10½D inches.
-
Uses your 12 VDC or 120 VAC with the MFJ-1312D.
THE MFJ-1312D IS NOT INCLUDED. I have these in stock if you need one.
Product Videos
Custom Field
Product Reviews
1 Review Hide Reviews Show Reviews
-
Everyone Needs one of these
If you need a device to check your equipment into a known good 50ohm load with an SWR of 1:1 This is that device and at full legal power. No one chasing you around the band calling you names. Just use it to set your power level and then check you SWR etc and your good to go. Every Ham needs a dummy load for testing your rig and not annoying others. Again The Ham Shop is your first choice for equipment and help of all things Ham.
