Loading... Please wait...

Our Newsletter

MFJ-2275, 75 Meter Mini-Dipole Includes MFJ-347 & 2 MFJ-1675T Hamstick Antennas

  • Image 1
  • Image 2
3.75 LBS
In Stock, Shipping Today
Calculated at checkout

Product Description

  • Use these inexpensive, lightweight, isolated mini-dipoles when space is limited for temporary or permanent installations.

  • Rotate to null QRM/noise and to focus your signal.

  • Includes One MFJ-347 & 2 MFJ-1675T Ham Stick Antennas


Assembly and tuning Instructions:

1 - Insert the stainless steel whip into the lower section ferrule about four inches and tighten the set screw.

2-  Screw the ferrule/whip assembly into the fiberglass loading coil section.

3-  Screw the fiberglass loading coil and stainless steel whip assembly into one of the 3/8 X 24 connections on the MFJ-347

4-  Repeat the above steps for the other antenna section.

5-  Install a VSWR meter at the transceiver and apply 10 to 25 watts of power.

6-  Adjust the VSWR meter and output frequency for lowest VSWR reading, indicating resonance.

7-  If resonant frequency is higher than desired, loosen the set screws and extend the stainless steel whips until the desired resonant frequency is found.

8-  Be sure to adjust both stainless steel whips the same amount.

9-  If resonant frequency is too low, loosen the set screws and adjust the whips further into the fiberglass sections.

10- Again, be sure to adjust both whips the same amount.

11-  For best results, adjustments should be made in small increments.


Caution: If required, cut off the bottom of the whips to ensure it does not extend down into the coil. Failure to observe this

precaution will cause extreme heat damage and void the warranty.


VSWR: At resonance, the VSWR should be 1.5:1 or less when properly matched. When tuning is complete, tighten the set screws securely.






Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!